infant seat
Britax Willow S Infant Car Seat Review
by britax

The Willow S pairs Britax's ClickTight install with an anti-rebound bar and an easy baseless install at the entry price of Britax's infant line, though it holds 5 lb less than the B-Safe 35 and the harness still needs rethreading.
- Rear-facing
What we like
ClickTight makes a seat-belt install simple: route the belt under the lid and press it closed, with no belt locking for a lap-shoulder belt. The Alpine base adds a ReboundReduce stability bar, and Britax says the seat is side-impact tested to FMVSS 213a.
The carrier installs without the base using European belt routing and is certified for aircraft without the base. Britax says the fabrics are machine washable and dryable with no added flame-retardant chemicals, and BabyGearLab gave it 7.8 out of 10 in its crash analysis.
Worth knowing
The weight limit is 30 pounds, 5 less than the B-Safe 35. The harness has 4 heights and must be rethreaded to move up.
Testers found the insert padding thin, the plastic handle plain and the belt threading under ClickTight fiddly. The stability bar can't be removed once installed, it fits mainly Britax strollers, and the warranty is a limited one year.
❮ Return to Best Infant Car Seats
Britax has retired the B-Safe infant seats and now sells the Willow family. The Willow S with Alpine base is Britax’s current entry infant seat sold on its own: a rear-facing carrier for babies from 4 to 30 pounds and 17 to 32 inches, on a base with Britax’s ClickTight install and a built-in anti-rebound bar.
We compared it against the owner’s manual, Britax’s product page and independent testing. Every size limit on this page comes from the Willow S user guide.
Our verdict: the Willow S is one of the easiest infant seats to get tight with a seat belt, and it adds an anti-rebound bar the B-Safe 35 never had. Just know that it stops at 30 lb, not 35.
If you own a B-Safe 35, read the recall section below first.
Why choose an infant seat and not a convertible?
A convertible seat can rear-face for years, so why buy a seat for the first year or so? Fit and convenience. An infant seat is shaped for small babies, and the Willow S has an inner harness loop and inner hip slots for babies under 11 lb. And you can lift a sleeping baby out in the carrier, click it into a stroller, and leave the base in the car.
Key features of the Britax Willow S

Image: Britax
- Rear-facing from 4 to 30 lb and 17 to 32 inches tall
- Alpine base with ClickTight: open a lid, route the seat belt underneath, close it
- ReboundReduce stability bar on the base
- Installs without the base, including European belt routing for taxis and travel
- Certified for aircraft when used without the base
- 4 rethread harness heights, plus inner settings for babies under 11 lb
- Fabrics Britax says are machine washable and dryable, with no added flame-retardant chemicals
- 6-year useful life
What changed from the Britax B-Safe 35
Britax lists the B-Safe 35 as a retired product, and it never named one Willow model as its replacement. The Willow S is simply where a B-Safe 35 shopper lands today: the entry seat of Britax’s current infant line, in the same price band.
| B-Safe 35 | Willow S | |
|---|---|---|
| Weight limit | 4–35 lb | 4–30 lb |
| Height limit | 32 in or less | 17–32 in |
| Base install | Lower anchors or seat belt | ClickTight or lower anchors |
| Anti-rebound bar | No | Yes (on base) |
| Baseless install | Yes | Yes, including European routing |
| Side impact | Britax SafeCell | Britax says tested to FMVSS 213a |
| Useful life | 6 years | 6 years |
| Status | Retired; some seats recalled | Current; no recall found |
The weight limit drops from 35 lb to 30 lb
Let’s be plain: the Willow S holds 5 lb less than the B-Safe 35. The B-Safe 35 was rated to 35 pounds, and the Willow S stops at 30.
In practice, the gap matters less than it sounds. Both seats top out at 32 inches, and the Willow S also requires at least 1 inch between the top of your baby’s head and the top of the head restraint. Most babies outgrow an infant seat by height or head room before weight, and the next step is a convertible seat either way. Every main rival we review is also rated to 30 lb.
What you gain is the install. ClickTight means you don’t have to lock the seat belt for a lap-shoulder install, and the anti-rebound bar braces the base against the vehicle seat back.
Own a B-Safe 35? Check the recall
Britax recalled certain infant seats under NHTSA recall 26C006, including B-Safe 35 seats made Aug 17, 2020 to Mar 4, 2021. A screw in the carry handle can loosen and the handle can partly detach, which can let a child fall. Not every B-Safe 35 is included. Check the model number on the label under the seat against Britax’s list.
If your seat is listed, Britax mails a free kit of two retention clips that fit without tools. Request it at crshubrecall.com or call 1-888-427-4829. Our Britax B-Safe 35 review has the details, and our car seat recalls page lists other campaigns.
The Willow S is not part of this recall. We found no recall for it at NHTSA or on Britax’s recall page.
Other versions: Willow SC, Cypress and Willow
Britax’s FAQ gives the Willow SC and Cypress the same 4–30 lb, 32 in limits, and both come with the same Alpine base. They cost more for fabric and insert upgrades, not for longer use. The plain Willow is sold only in the Willow Brook travel system, with a different base (Aspen).
What are the size limits of the Willow S?
The Willow S is rear-facing only. According to the manual, your baby can ride in it while:
- They weigh 4 to 30 pounds, and
- They’re 17 to 32 inches tall, and
- The top of their head is at least 1 inch below the top edge of the head restraint.
Stop using it as soon as your baby reaches any of those limits. The harness straps go in the position closest to, and below, your baby’s shoulders, with the chest clip at armpit level. The inner harness loop and inner hip slot are for babies up to 11 lb, and the infant positioning pillow (select models) is for babies under 11 lb.
For why both limits matter, see our guide to height and weight limits for rear-facing seats.
How big is it, and will it fit your car?
Britax lists the Willow S at 28.1 inches long, 16.9 inches wide and 24.11 inches tall. Under 17 inches wide is friendly for smaller back seats; see our three-across guide if you’re squeezing in more than one seat.
Britax doesn’t publish a carrier weight for the Willow S. Expect about 9–10 lb (BabyGearLab measured 9.7 lb) before your baby is in it, which is mid-pack for the category. The base stays in the car.
How safe is the Willow S?
The manual says the seat conforms to all applicable federal motor vehicle safety standards, and Britax says it is side-impact tested to FMVSS 213a, the updated federal side-impact standard. We haven’t crash-tested it ourselves.

Image: Britax
Two features target rebound, the motion back toward the vehicle seat in a crash. The ReboundReduce stability bar sits on the base, and Britax recommends keeping the carry handle in Position 1 in the car for its built-in rebound reduction. In BabyGearLab’s own crash analysis, the Willow S scored 7.8 out of 10. That’s their analysis, not ours, but it’s a useful check.
Like the B-Safe 35, it has a 6-year useful life from its date of manufacture. Replace it after a moderate or severe crash.
How hard is it to install?
With the Alpine base

Image: Britax
ClickTight is the star. For a lap-shoulder belt, open the ClickTight lid, route the belt underneath, buckle it, pull out the slack and press the lid closed. You don’t lock the seat belt. With a lap-only belt, you must lock it first. Or use the lower anchors, which store in the base. Never use the belt and lower anchors together, and there’s no top tether.
Set the angle with the recline foot until the blue marker sits between the lines. The base should move less than 1 inch at the belt path.
Be honest with yourself about one thing: the stability bar can’t be removed once installed. Testers also found threading the belt under ClickTight fiddly, and the lid takes a firm push to close. If your car has lower anchors in the seating position you want, many parents find that route easier.
Without the base
For taxis, rideshares or a second car, you can install the carrier alone with a lap-shoulder belt (the European routing, around the back of the carrier, usually gives the firmest fit) or a lap belt. Lock the vehicle belt, or use a locking clip if it can’t lock, and check that the level line on the carrier is level with the ground. Our taxi and rideshare guide has more tips.
On an airplane
The carrier is certified for aircraft without the base. The Alpine base is not, so leave it at home. A window seat works best. More in our airplane car seat guide.
Comfort and everyday use
The harness has 4 heights, and you rethread it to move up. That’s done with the seat out of the car and empty, so it’s a small chore every few months. Testers found the insert padding on the thin side and the plain plastic handle uncomfortable on longer carries. The canopy (UPF 50+, per Britax) is on the small side, and the buckle release button is recessed.
The cover is the easy part: Britax says you can machine wash and dry it, and it has no added flame-retardant chemicals.
Stroller compatibility
This is the Willow S’s narrowest point. The manual warns that not all strollers are compatible, and it clicks into Britax strollers, some only with an adapter. Britax sells it with the Brook+ stroller as the Willow Brook S+ travel system. If you already own a non-Britax stroller, check Britax’s compatibility chart before you buy.
How it compares
- Chicco KeyFit Max: same 4–30 lb, 32 in limits, a no-rethread harness, and far wider Chicco stroller fit. The Willow S’s ClickTight makes a seat-belt install simpler.
- CYBEX Aton G2: a load-leg base and a lighter carrier, in a higher price band.
- UPPAbaby Mesa V3: the pick for UPPAbaby stroller families, also in a higher price band.
- Graco SnugRide SnugFit DLX: the value alternative, with an anti-rebound bar and wide Graco stroller fit.
Best Car Seat Hub’s final verdict

- ClickTight base makes seat-belt installs simple, no belt locking for lap-shoulder belts
- Anti-rebound bar on the base, plus a rebound-reducing handle position
- Easy baseless install with European routing, and certified for aircraft without the base
- Strong independent crash analysis (BabyGearLab 7.8/10)
- Washable fabrics with no added flame retardants
- Fits small babies from 4 lb, with inner settings up to 11 lb

- 30 lb weight limit, 5 lb less than the B-Safe 35
- Rethread harness with 4 heights
- Limited stroller compatibility outside Britax
- Thin insert padding and a plain plastic handle
- The stability bar can’t be removed once installed
- Limited one-year warranty
Who it’s for
Parents who’ll install with a seat belt, or move the seat between cars, and want Britax’s ClickTight and an anti-rebound bar at the entry price of Britax’s infant line. It’s also a natural fit if you plan to use a Britax stroller.
Who should skip it
- Families committed to a non-Britax stroller. The KeyFit Max or SnugRide fits far more strollers.
- Parents who want a no-rethread harness. The KeyFit Max moves through its heights without rethreading.
- Anyone expecting 35 lb of use. The Willow S stops at 30 lb.
Want to see how it ranks against other infant seats? Head back to our safest infant car seats list.
- Seat type
- Rear-facing-only infant seat (carrier with Alpine base)
- Rear-facing
- 4–30 lb, 17–32 in; top of head at least 1 in below the top edge of the head restraint
- Small babies
- Inner harness loop and inner hip slot up to 11 lb; infant positioning pillow under 11 lb (select models)
- Harness
- 4 heights, rethread
- Anti-rebound
- ReboundReduce stability bar on the Alpine base (can't be removed once installed)
- Carrier weight
- About 9–10 lb (BabyGearLab measured 9.7 lb)
- Dimensions
- 28.1 in L x 16.9 in W x 24.11 in H (Britax)
- Installation
- Alpine base with ClickTight (lap-shoulder or locked lap belt) or lower anchors, never both; no tether; baseless with European, lap-shoulder or lap-belt routing
- FAA
- Certified for aircraft without the base only
- Federal standard
- Conforms to all applicable FMVSS (manual); Britax says it is side-impact tested to FMVSS 213a
- Fabrics
- Machine wash and dry; no added flame-retardant chemicals (Britax)
- Useful life
- 6 years from the date of manufacture
- Warranty
- Limited 1 year from original purchase