infant seat
Baby Trend EZ-Lift PLUS Infant Car Seat Review
by babytrend

The EZ-Lift PLUS is a light, budget-friendly, FAA-certified carrier with a sensible base, but its 29.5-inch height limit, rethread harness and lock-off-free belt install make it a seat to choose with your eyes open.
- Rear-facing
What we like
The carrier is light and certified for aircraft (use it without the base on a plane). The base installs with self-locking LATCH webbing or the vehicle belt, lap-only belts included, and has an elevation foot and a two-zone angle indicator to get the recline right. The carrier also installs without the base.
The carry handle works as a rebound limiter in its Rebound position for babies up to 22 pounds, the harness has a No-Twist Harness Indicator, and the 1-year warranty is longer than some budget rivals offer.
Worth knowing
The 29.5 inch height limit is shorter than most rivals, so many babies will outgrow it by length first. The harness has to be rethreaded by hand, and the base has no lock-off, so some lap/shoulder belts need a locking clip.
The handle's rebound benefit stops at 22 pounds, there's no load leg, and the owner's manual doesn't mention the side-impact standard. The seat expires 7 years after it was made.
❮ View All Cheap Infant Car Seats
If you’re shopping for an infant seat on a tight budget, the Baby Trend EZ-Lift PLUS will turn up again and again, on its own and in Baby Trend travel-system bundles. It’s light, it’s simple, and it’s certified for airplanes. It also has a couple of limits you should know about before you buy.
We built this review from Baby Trend’s current owner’s manual (model CS02, revision CS02_120624), its product page and NHTSA’s recall records. We haven’t crash-tested or installed it ourselves.
Our verdict: the EZ-Lift PLUS is a solid, no-frills carrier for budget-minded parents who value a light seat and airplane use. Just check the 29.5-inch height limit against your baby’s growth, and be ready for a rethread harness and a base with no lock-off.
Why choose an infant seat?
A convertible seat lasts for years, but an infant seat is easier in the first months. You can carry a sleeping baby inside in the carrier, click it into a compatible stroller, and leave the base in the car. The EZ-Lift PLUS takes babies from 4 pounds.
Key features of the Baby Trend EZ-Lift PLUS
- Rear-facing from 4 to 30 lb and up to 29.5 inches, according to the manual
- Light carrier: about 7.5 lb (under 8 lb), per Baby Trend
- Base with an elevation foot and a two-zone angle indicator, installed with LATCH or the vehicle belt
- Installs without the base using a lap or lap/shoulder belt
- Carry handle with a Rebound position for babies up to 22 lb
- Rethread harness with four shoulder-strap heights and a No-Twist Harness Indicator
- Certified for aircraft, a 7-year life and a 1-year warranty
Image: Baby Trend
What changed from earlier EZ-Lift versions
There’s no older EZ-Lift review on our site, so this is a fresh review rather than an update. The PLUS is Baby Trend’s current base model in the EZ-Lift line. We couldn’t confirm the exact differences from the original EZ-Lift on a primary Baby Trend page, so we’re not listing them.
Why do some listings show a different weight limit?
Some store listings still show an older name with a higher number in it. The seat’s label and manual say 30 lb, and that’s the limit to follow. The manual also gives 29.5 inches as the height limit; you may see other heights on retailer pages. When a listing and your seat’s label disagree, the label wins.
What are the size limits of the EZ-Lift PLUS?
The EZ-Lift PLUS is rear-facing only. According to Baby Trend’s manual (§2.1, p.4), your baby can ride in it while they:
- Weigh 4 to 30 pounds, and
- Are 29.5 inches (74.9 cm) or less, and
- Have the harness straps at or just below the shoulders in the highest slot.
Your baby must meet all three. Once the shoulders rise above the top harness slot, or your baby passes 30 lb or 29.5 in, it’s time for a convertible seat. Baby Trend also recommends keeping your child rear-facing as long as possible, to the seat’s limits and at least age 2.
Be honest with yourself about height. At 29.5 inches, this is the shortest limit among the budget infant seats we’ve reviewed; rivals like the LiteMax 30 go to 32 inches. Long babies will often outgrow it sooner, so budget for the next seat earlier. Our guide to height and weight limits for rear-facing seats explains why both matter.
The infant inserts are only for babies 4 to 18 lb, and they don’t come with every model. The manual also cautions that pre-term and special-needs babies may have difficulties in a reclined seat, so talk to your pediatrician first. Never add padding thicker than ¼ inch behind or under your baby.
How big is it, and will it fit your car?
Baby Trend lists the carrier at 7.5 lb and 14 lb with the base. That’s light, which you’ll feel every time you carry it in from the car. The seat measures 16.5 inches wide, 26.5 inches long and 24 inches tall, a reasonable width for smaller back seats. For tight rows, see our three-across guide.
Use it in the back seat whenever you can. The manual allows the front seat only if there’s no active air bag, with the vehicle seat moved fully back.
How safe is the EZ-Lift PLUS?
The manual says the seat conforms to all applicable Federal Motor Vehicle Safety Standards, and Baby Trend says it’s crash tested to FMVSS 213. NHTSA’s recall database showed no recalls for the EZ-Lift when we checked, and no open investigations.
On side impact: Baby Trend’s product page shows a generic FMVSS 213/213a badge, but the owner’s manual doesn’t mention the side-impact standard, so check the label on the seat you buy.
About rebound: the carry handle doubles as a rebound limiter in its Rebound position, for babies up to 22 lb. Baby Trend says the handle acts as an anti-rebound bar in its forward position. Above 22 lb, or once your baby’s feet touch the handle, the manual says to use the Carry position instead, so that benefit ends there. There’s no load leg.
How hard is it to install?
With the base
LATCH is the easier path. Clip the base’s lower-anchor connectors on, press the base down and pull the webbing tight; the manual says the webbing locks automatically. Rear-facing infant seats don’t use the top tether.
With a seat belt, take your time. The base has no lock-off, so you’ll need a belt that locks. Lap-only belts are allowed. Some lap/shoulder belts need a locking clip. The manual has a storage spot for one, but also tells owners to call Baby Trend (1-800-328-7363) to get one, so check your box. Safe in the Seat flags this seat as one to use with caution if you want an easy install.
To level it:
- Use the elevation foot on the base.
- Check the angle indicator: the bubble centered for babies 4–22 lb, the level line parallel with the ground for over 22 lb to 30 lb.
- A rolled towel or pool noodle is allowed if needed, reaching at least 1 inch past the edge of the base.
Image: Baby Trend
When you’re done, push down and side to side at the head end; the belt shouldn’t loosen. A certified car seat technician (CPST) can check your work.
Without the base
For taxis or a second car, route a lap or lap/shoulder belt through the carrier’s belt hooks, with the shoulder belt in front, and use the same angle indicator. The manual doesn’t describe wrapping the shoulder belt behind the shell. See our taxi and rideshare guide.
Image: Baby Trend
On an airplane
The seat is certified for aircraft. Leave the base at home and install the carrier rear-facing on a forward-facing airplane seat, the same way as the baseless car install. Check your airline’s policy too. More tips in our airplane car seat guide.
Everyday use and care
The handle has five positions, but only Rebound or Carry are allowed in the car. To raise the harness, you take the seat off the base, turn it over, unhook the straps from the back plate and rethread them with the included threading tool. It’s a small chore you’ll repeat a few times.
Spot-clean the harness (never launder it), wash the pad per its tag, and don’t use lubricants on the buckle or LATCH parts. Never use the seat without its pad. Replace the seat and base after any crash, even a minor one, and stop using it 7 years from the date of manufacture (the label is underneath).
Base and stroller compatibility
Extra bases come from Baby Trend; never mix in another brand’s base. The seat works with Baby Trend strollers and travel systems that list the EZ-Lift PLUS; check the stroller’s manual and Baby Trend’s compatibility page before you buy.
EZ-Lift PLUS vs EZ-Lift PRO
Baby Trend sells a step-up EZ-Lift PRO with the same 4–30 lb rating (AAP listing). Compare features on Baby Trend’s site before deciding whether the upgrade is worth it to you.
How it compares
- Evenflo LiteMax 30 (8.8): also budget-priced and light, but it goes to 32 inches, starts at 3 lb and has a lock-off base. It’s the stronger budget pick for most families.
- Graco SnugRide SnugFit DLX (9.3): costs more, but adds a true anti-rebound bar, a no-rethread harness and a 32-inch limit.
- Evenflo LiteMax NXT (8.3): a no-rethread headrest on most versions and an optional load leg, at a higher price.
Where the EZ-Lift PLUS wins: it’s light, it’s budget-friendly, and its 1-year warranty beats the 90 days Evenflo offers.
Best Car Seat Hub’s final verdict

- Light carrier, about 7.5 lb
- Budget-friendly
- Certified for aircraft
- LATCH or belt base, with lap-only belts allowed
- Two-zone angle indicator and elevation foot
- Installs without the base
- 1-year warranty, longer than some budget rivals
- No recalls found for the EZ-Lift

- 29.5-inch height limit, shorter than most rivals
- Rethread harness
- No lock-off on the base; some belts need a locking clip
- Rebound handle benefit stops at 22 lb; no load leg
- Manual doesn’t mention the side-impact standard
- 7-year life
Who it’s for
Parents on a budget who want a light, FAA-certified carrier that also clicks into Baby Trend strollers. It suits families who’ll install with LATCH, fly with the baby, or carry the seat a lot.
Who should skip it
- Parents of long babies, or anyone hoping to stretch an infant seat as long as possible. Look at a 32-inch seat.
- Families installing with a seat belt who want a lock-off for an easy, tight fit.
- Anyone who wants an anti-rebound bar, a load leg or a no-rethread harness.
Want to see how it ranks? Head back to our best cheap infant car seats list.
- Seat type
- Rear-facing-only infant seat (carrier with stay-in-car base)
- Rear-facing
- 4–30 lb and 29.5 in (74.9 cm) or less; harness at or just below the shoulders in the top slot (owner's manual §2.1)
- Infant inserts
- Only for babies 4–18 lb (not included with all models)
- Harness
- 5-point, rethread; four shoulder-strap heights, two crotch-strap positions
- Harness extras
- No-Twist Harness Indicator (Baby Trend)
- Handle in the car
- Rebound position for babies 22 lb or less; Carry position over 22 lb or if the feet touch the handle
- Load leg / anti-rebound bar
- No load leg; no separate anti-rebound bar
- Base install
- Lower anchors (self-locking webbing) or vehicle belt; no lock-off; lap-only belts allowed
- Base leveling
- Elevation foot; angle indicator with two zones (4–22 lb bubble, over 22–30 lb level line)
- Baseless install
- Lap or lap/shoulder belt through the carrier's belt hooks
- Aircraft
- Certified for aircraft; use the carrier without the base
- Federal standard
- Conforms to all applicable Federal Motor Vehicle Safety Standards (owner's manual); crash tested to FMVSS 213 (Baby Trend)
- Carrier weight
- 7.5 lb; 14 lb with the base (Baby Trend)
- Dimensions
- 16.5 in wide × 26.5 in long × 24 in tall (Baby Trend)
- Useful life
- 7 years from the date of manufacture
- Warranty
- 1 year from purchase