booster seat
Graco TurboBooster 2.0 LX Highback Booster Review
by graco

A budget highback booster with LATCH and the same 40–100 lb limits in both modes: the easy pick if you want the booster held in place when it's empty, but unlike the Affix it doesn't fit a child under 40 lb.
- Booster
What we like
The limits are simple: 40-100 pounds and 43-57 inches in both highback and backless mode, so one seat can cover your child until the adult belt fits (typically around 4 feet 9 inches). LATCH means an empty booster stays secured without buckling it, and the straps tighten from the front.
The armrests press in with no screws, a belt-positioning clip is included for backless mode, and the cover is machine washable. Car Seats for the Littles measured it at about 16.5 inches at its widest, and NHTSA lists no recall for the 2.0 LX. It's budget-friendly.
Worth knowing
It starts at 40 pounds, 43 inches and age 4, higher than the Affix's 30-pound highback minimum, so a 30-39 pound child doesn't fit it yet. The hook-style LATCH connectors take a press, twist and pull to remove.
The cup holder can't be removed once attached, and the storage compartment comes only on select models. It can't overhang the front of the vehicle seat or leave a gap behind it from a fixed headrest, so check the fit in your car. Like every booster, it isn't FAA certified for airplanes.
If you loved the Graco Affix, you’re probably wondering where it went. Its LATCH-equipped highback lives on in the TurboBooster line, and the Graco TurboBooster 2.0 LX Highback Booster with Latch System is the current version of the LX line. It’s a highback booster that converts to a backless booster, with lower-anchor straps that keep the seat in place in your car.
The short version: it fits kids 40–100 lb and 43–57 inches tall, at least 4 years old, in both highback and backless mode. It adds LATCH and screw-free armrests to the familiar TurboBooster shell, and it sits in the budget price band. One big catch for Affix families: the minimum is higher than the Affix’s.
This review is based on Graco’s owner’s manual, Graco’s product page, NHTSA recall records and CPST reviews. We did not crash-test or install this seat ourselves.
What changed from the Graco Affix
The lineage: Affix → TurboBooster LX → TurboBooster 2.0 LX
Graco no longer lists the Affix. According to Car Seats for the Littles (CSFTL), a CPST-run review site, the Affix was replaced with the TurboBooster LX, which combined the Affix’s LATCH system with the TurboBooster shell. The TurboBooster 2.0 LX is the current version of the LX line. If you see the original TurboBooster LX on a shelf, check its own label for its limits.
The minimum went up: 30 lb → 40 lb in highback
This is the change that matters most. According to CSFTL, the Affix’s highback mode started at 30 lb, 38 inches and age 3. The TurboBooster 2.0 LX starts at 40 lb, 43 inches and age 4, per Graco’s manual.
A 30–39 lb child doesn’t fit the TurboBooster 2.0 LX. If your child is in that range, keep them in a harnessed car seat until they meet all three minimums.
At the top end nothing changed. The Affix maxed out at 100 lb in both modes, and so does the 2.0 LX.
Same headrest, still no armrest screws
The 2.0 LX keeps a 6-position headrest. Its armrests simply press into the base, with no screw, which was also true of the Affix. The cup holder ships stored in the base. The manual says it must be installed, and it can’t be removed once attached, so plan for that if you’re fitting a tight back seat.
LATCH: same job, front-adjust straps
Like the Affix, the 2.0 LX uses hook-style lower-anchor connectors on straps that you tighten by pulling straps at the front of the seat. More on how it works below.
A note on TurboBooster recalls
If you search “TurboBooster recall,” you’ll find NHTSA recall 16C-004 (June 2016). It covered six original TurboBooster models (1963973, 1963974, 1963975, 1963976, 1967886 and 1975173) made between Dec 22, 2015 and Apr 5, 2016. The printed manual left out that the booster should be belted in even when it’s empty, so Graco said those seats didn’t comply with FMVSS 213. The fix was a new printed manual. Those seats have all passed Graco’s 10-year life.
That recall doesn’t cover the TurboBooster 2.0 LX. As of our check, NHTSA lists no recall for the 2.0 LX. The Affix had no recalls either.
Sources: Graco manual; Affix limits per CSFTL
TurboBooster 2.0 LX vs TurboBooster 2.0 Highback (belt-only)
Graco sells two TurboBooster 2.0 highbacks with the same limits. The LX adds LATCH and screw-free armrests.
| TurboBooster 2.0 LX Highback | TurboBooster 2.0 Highback | |
|---|---|---|
| Limits (both modes) | 40–100 lb, 43–57 in, age 4+ | 40–100 lb, 43–57 in, age 4+ |
| LATCH | Yes, hook-style, front-adjust | No, belt-only |
| When the seat is empty | Latch it or buckle it | Buckle it |
| Armrests | Press in, no screw | Set with a height-adjustment screw |
| Headrest positions | 6 | 6 |
| FAA certified | No | No |
| Useful life | 10 years | 10 years |
Pick the LX if you want LATCH and no armrest screws. If you’re happy buckling an empty booster, the belt-only 2.0 does the same job for a little less.
Is your child ready for a highback booster?
A belt-positioning booster lifts your child so the adult seat belt fits: the lap belt low across the hips and upper thighs, and the shoulder belt across the middle of the shoulder, not the neck or belly.
Before you switch, keep your child in a harnessed seat until they outgrow it by height or weight, and make sure they’re mature enough to sit upright for the whole ride. Check your state’s car seat laws and guidance from the AAP and NHTSA.
What are the child size limits?
Here’s what the TurboBooster 2.0 LX manual lists:
| Mode | Weight | Height | Age |
|---|---|---|---|
| Highback booster | 40–100 lb | 43–57 in | At least 4 years old |
| Backless booster | 40–100 lb | 43–57 in | At least 4 years old |
Highback fit: according to the manual, the shoulder belt should sit between your child’s neck and the edge of the shoulder, and the belt guides should be even with or just above the shoulders. Raise the headrest through its 6 positions as your child grows. CSFTL measured the highest shoulder-belt guide at about 20 inches. According to Car Seats for the Littles, the highback is outgrown when your child’s ears are above the top of the vehicle seat back or the booster’s headrest.
When to go backless: the manual says your child’s ears must be below the top of the vehicle seat back or headrest. If your vehicle seat doesn’t give that support, stay in highback mode.
When your child is done with a booster: once the adult belt fits properly, typically at 4 feet 9 inches tall and between ages 8 and 12, per the manual.
How safe is the Graco TurboBooster 2.0 LX?
According to the manual, it meets or exceeds all applicable requirements of FMVSS 213, the federal standard for car seats and boosters sold in the US. Graco also markets it as “ProtectPlus Engineered”; that’s Graco’s own claim, not an independent rating.
Let’s clear up the biggest LATCH myth. LATCH keeps the booster in place, with or without your child in it; it never holds your child. The vehicle’s lap-and-shoulder belt restrains your child, every ride. Graco allows LATCH in booster mode up to 100 lb, and the real benefit is practical: an empty booster stays secured without you buckling it. It doesn’t add crash protection for your child.
The manual’s belt-fit basics:
- Use it only with a lap-and-shoulder belt, never a lap-only belt.
- The lap belt goes in front of both armrests, low on the hips.
- The shoulder belt goes under the armrest on the buckle side, then through the headrest belt guide in highback mode.
- Latch or buckle the booster whenever it’s empty, so it can’t fly around in a crash.
What about IIHS? The Affix’s old IIHS “Best Bet” doesn’t carry over. IIHS ran its booster ratings from 2008 to 2024 and has no rating for the TurboBooster 2.0 LX.
How easy is it to install and use?
Image: Graco
LATCH is optional, and it works in both highback and backless mode. According to the manual:
- Set the booster flat on the vehicle seat, facing forward.
- Press the button on the front of the base and pull the straps out to full length.
- Attach the hook connectors to your vehicle’s lower anchors, with the straps untwisted.
- Push the booster back and pull the straps at the front to take out the slack.
If the anchors get in the way of the belt or buckle, or your seating position has none, store the connectors and just buckle the booster when it’s empty. Never put two connectors on one anchor bar unless your vehicle maker allows it.
Taking it out is the fiddly part. The hook connectors need a press, twist and pull to release, the same complaint parents had about the Affix.
The booster must sit flat against the vehicle seat back and not hang off the front of the vehicle seat. In backless mode, use the included belt-positioning clip if the shoulder belt falls outside the marked zone.
Will it fit in your vehicle?
The 2.0 LX is about 16.5 in at its widest (the cupholder), as measured by Car Seats for the Littles; some retailer listings give a larger figure, so measure your back seat if you’re fitting three across. CSFTL measured the Affix at 18 inches at its widest, so the newer shell is the slimmer of the two by that measure.
It’s light, too: about 8.4 lb in highback mode, per CSFTL’s measurement; retailer listings give somewhat higher figures.
The Safety Surround version
Graco also sells a version with its Safety Surround side-wing design; check that seat’s own label and manual for its limits. This review covers the Latch System model (2203030).
Comfort, cup holder, storage and cleaning
Image: Graco
Kids get armrests, one cup holder and a padded seat. A hidden storage compartment comes on select models; CSFTL found theirs small and a little hard to open. In highback mode, the headrest gives sleepy kids somewhere to lean.
According to the manual, you can machine wash the cover cold on a delicate cycle and drip-dry it. No bleach. The lower-anchor straps are surface-wash only.
Not for airplanes: the manual says it’s not certified for aircraft use, since planes don’t have shoulder belts. It has a 10-year life from the date of manufacture, so check the date-of-manufacture label.
BestCarSeatHub’s Final Verdict
The TurboBooster 2.0 LX is the easy, affordable way to keep a booster secured when nobody’s in it. Just know it starts later than the Affix did.

- 40–100 lb, 43–57 in in both highback and backless mode
- LATCH holds the booster in place, so no buckling an empty seat
- Armrests press in, with no screws
- 6-position headrest; converts to backless
- Belt-positioning clip included for backless mode
- Narrow and light by CSFTL’s measurements
- No NHTSA recall listed for the 2.0 LX
- Budget-friendly price

- Starts at 40 lb, 43 in and age 4: higher than the Affix’s 30 lb highback minimum
- Hook connectors are fiddly to remove
- Cup holder can’t be removed once attached
- Storage compartment only on select models, and it’s small
- Fixed vehicle headrests or short vehicle seats can rule out some positions
- Not FAA certified (no booster is)
Who it’s for
- Affix owners whose child has outgrown it, or families who liked the Affix and want its current equivalent
- Kids who are at least 4 years old, 40 lb and 43 in, and ready to sit still for the whole ride
- Parents who want LATCH to keep an empty booster in place, on a budget
Who should skip it
- Parents of a 30–39 lb child: it won’t fit yet. Stay in a harnessed seat.
- Families happy to buckle an empty booster: the belt-only TurboBooster 2.0 Highback has the same limits
- Anyone who wants rigid LATCH: compare the Chicco KidFit ClearTex Plus 2-in-1
Bottom line: if you want a simple, affordable booster that stays put when it’s empty, the Graco TurboBooster 2.0 LX is an easy one to recommend. See how it compares in our best booster seats guide.
- Highback booster weight
- 40–100 lb
- Highback booster height
- 43–57 in
- Backless booster weight
- 40–100 lb
- Backless booster height
- 43–57 in
- Minimum age
- At least 4 years old
- When to stop using a booster
- When the adult belt fits, typically about 4 ft 9 in and ages 8–12
- Installation
- Vehicle lap-and-shoulder belt; lower anchors (LATCH) optional to hold the booster in place
- Lower anchor connectors
- Hook-style, on straps, tightened from the front
- Headrest positions
- 6
- Armrests
- Press in, no screw
- Backless belt-positioning clip
- Included
- Cup holder
- 1, must be installed (can't be removed once attached)
- FAA certified
- No
- Useful life
- 10 years from date of manufacture
- Cover care
- Machine wash cold, delicate cycle, drip-dry
- Federal standard
- Meets FMVSS 213 (per the manual)
- Model number
- 2203030